Boom Proximity Sensor Installation - Raven AutoBoom XRT Installation Manual

C 4
HAPTER
3. On the center frame, use two provided 2-9/16" x 3-1/2" U-bolts to loosely install the rotary sensor bracket to
the lower horizontal tube positioned between the center rack and the center frame. The sensor mounts on the
right side of the center. The connector on the sensor will point toward the right side of the machine.
4. Install the rotary sensor link to the rotary sensor bracket arm and to the rotary sensor strap.
5. Using two wrenches, secure the rotary sensor link.
6. Adjust the rotary sensor bracket and the rotary sensor strap until the rotary sensor arm is vertical.
FIGURE 15. Rotary Sensor Arm Orientation
Sensor Arm
Orientation
CENTER RACK POSITION INSTALLATION
1. Use the provided U-bolts to install the center rack position bracket on the tube near the top of the right-hand
damper.
FIGURE 16. Center Rack Position Bracket
U-Bolt Should be
Mounted 1.5" From
the Bottom
28
Note the Distance
the Sensor is
Threaded
Center Rack
Position Target
AutoBoom® XRT Installation Manual for AGCO RoGator
Approximately
4 inches