Small Tree - Raven AutoBoom XRT Installation Manual

FIGURE 9. Installed Dampers

SMALL TREE

1. Unfold the booms.
2. Identify the damper installation location.
FIGURE 10. Damper Installation Location (Booms Unfolded)
3. Loosen nuts on the threaded rod holding the spring to remove as much tension as possible. Do not re-tighten
the spring after installation.
NOTE: It will be necessary to purchase springs from your AGCO dealer if the machine is not already
equipped with the spring.
4. Loosen the 3/4"-10 nut holding the threaded rod and spring.
016-0237-002 Rev. A
HYDRAULIC SYSTEM INSTALLATION
Damper
Installation
Location
Existing
Hole
Damper
Damper
Mounting
Bracket
Insert Bolt
so the Head
Faces the
Front of
Machine
15