Installing And Upgrading System Ui Software - Xerox DocuPrint t 180 System Generation Manual
Xerox laser printing systems system generation guide
Hide thumbs
Also See for DocuPrint t 180:
- Message manual (356 pages) ,
- Configuration manual (276 pages) ,
- System configuration manual (132 pages)
Table of Contents
Advertisement
SYSGEN AND SYSGEN-RELATED PROCEDURES
Installing and upgrading System UI software
Materials required
4-2
Use the information given below when installing or upgrading System
UI software.
System UI diskette.
Time required
System UI software installation takes about 5 minutes to complete.
Procedure
To install or upgrade System UI software, follow these steps:
Step 1.
Select "Exit to DOS" from the System Control menu.
Step 2.
Select "Yes" from the "Exit to DOS" window.
Step 3.
Insert the System UI software diskette.
Step 4.
Key in A: and press <ENTER>.
Step 5.
Key in INSTALL and press <ENTER>.
Step 6.
At the "Xerox DocuPrint 180 System UI Setup" window, select
"CONTINUE".
Step 7.
At the "Xerox DocuPrint 180 System UI Setup" Message window,
select "CONTINUE".
Step 8.
At the "Xerox DocuPrint 180 PC UI System Configuration" window,
select "CONTINUE".
Step 9.
At the "Destination for Xerox DocuPrint 180 System UI" window,
select "CONTINUE"
Step 10.
Select "Exit Windows" in the "Xerox DocuPrint 180 System UI Setup
Exit Message" window.
Step 11.
Remove the diskette.
System UI software installation is now complete. If you are
performing an upgrade, press the Reset button to finish the
procedure. Proceed to the "Installing or upgrading System UI dialog"
procedure.
XEROX DOCUPRINT 180 LPS SYSTEM GENERATION GUIDE
Advertisement
Table of Contents
