Installing Or Upgrading System Ui Dialog - Xerox DocuPrint t 180 System Generation Manual
Xerox laser printing systems system generation guide
Hide thumbs
Also See for DocuPrint t 180:
- Message manual (356 pages) ,
- Configuration manual (276 pages) ,
- System configuration manual (132 pages)
Table of Contents
Advertisement
Installing or upgrading System UI dialog
XEROX DOCUPRINT 180 LPS SYSTEM GENERATION GUIDE
Use the information given below when installing or upgrading System
UI dialog.
Time required
System UI dialog installation takes about 5 minutes to complete.
Procedure
To install System UI dialog, follow these steps:
Step 1.
Insert the UI Dialog software diskette into the drive. If needed,
perform steps a. and b which follow.
a.
Select "Exit to DOS" from the System Control menu.
b.
Select "Yes" from the "Exit to DOS" window.
Step 2.
If A> does not display, key in A: and press <ENTER>.
Step 3.
Key in INSTALL and press <ENTER>.
Step 4.
At the "Xerox DocuPrint 180 UI Dialog Setup" window, select
"Continue".
Step 5.
At the "Xerox DocuPrint 180 UI Dialog Message" window, select
"Continue".
Step 6.
At the "Xerox DocuPrint 180 PC UI System Configuration" window,
select "Continue".
Step 7.
At the "Destination for Xerox DocuPrint 180 UI Dialog" window,
select "Continue".
Step 8.
At the "Xerox DocuPrint 180 UI Dialog Setup Exit Message" window,
select "Exit Windows".
Step 9.
Remove the diskette from the drive. If you are performing an
upgrade, press the Reset button to finish the procedure.
SYSGEN AND SYSGEN-RELATED PROCEDURES
4-3
Advertisement
Table of Contents
