Xerox DocuPrint t 180 System Generation Manual page 24

SAMPLE SYSTEM CONFIGURATIONS
Option
0) None
1) Full memory test
2) Auto boot
3) Message display
4) Shared disk
5) MICR mode default
6) On-line interface (if
installed)
7) Xerox
DocuPrintServer
(formerly XPSM)
8) Kanji
9) Ethernet (if installed)
3-4
Table 3-4. Sample configurations
Description
Returns you to the base system configuration display screen.
Determines the amount of system memory test at power on.
Determines whether auto boot is enabled at power on.
Determines whether boot diagnostic messages display at power on.
Adds or removes the shared disk option.
This option is not supported on the DocuPrint 180 LPS. Selection of option
5 has no effect on the LPS.
Adds or removes the MICR mode default option.
Displays the following question:
DOES THIS SYSTEM HAVE AN ONLINE INTERFACE?
ENTER 'Y' OR 'N'.
If you enter N, the online feature is removed from the system being
generated.
If you enter Y, the configuration options are automatically selected by the
system and the display returns to the base configuration.
Adds or removes the Xerox DocuPrintServer (formerly XPSM)).
This option is not supported on the DocuPrint 180 LPS. Adds or removes
Kanji.
This option is not supported on the DocuPrint 180 LPS. Selection of option
9 has no effect on the LPS
Displays the following question:
IS THIS SYSTEM CONNECTED TO A XEROX ETHERNET? ENTER 'Y'
OR 'N'.
If you enter N, the Ethernet feature is removed from the system being
generated.
If you enter Y, the following suboptions display:
ETHERNET CHANGE LIST:
1) NONE
2) READ PRINTER'S ADDRESS
3) ETHERNET NETWORK ADDRESS
Selecting NONE results in no Ethernet changes.
Selecting READ PRINTER'S ADDRESS results in the printing system
providing its internal address as a parameter to the sysgen processor.
This address is shown in table 3-2, Base system configuration for
DocuPrint 180 LPS, in both hexadecimal and decimal format. The decimal
value is preceded by an asterisk (*). (The printing system internal address
is set by Xerox at the time of manufacture.)
Selecting ETHERNET NETWORK ADDRESS results in a prompt for the
address of the Ethernet network. For a decimal value, enter six zeros. A
value not preceded by an asterisk is assumed to be hexadecimal. (The
network address is assigned by Xerox. Consult your network system
administrator for the correct assignment.)
XEROX DOCUPRINT 180 LPS SYSTEM GENERATION GUIDE