Xerox DocuPrint t 180 System Generation Manual page 37

Step Action
12. Key in SYSGEN and press <ENTER>.
13. Enter N and <ENTER> to allow the sysgen
to continue. Go to step 15.
14. Enter Y and <ENTER> to allow the
previously entered ID to be changed.
Key in the new ID and press <ENTER>.
NOTE: When you enter N, sysgen will
continue. If you enter Y, you will be able to
change the system ID again.
15. If configured, enter the Ethernet address
provided by Xerox and press <ENTER>.
16. Enter Y or N and <ENTER>. A Y and
<ENTER> response causes the change
menu to display. Each time a change is
made, the change question is asked until an
N and <ENTER> is entered, and the sysgen
program continues.
17.
To discard the changes you just made and
continue sysgen, enter Y.
To save the changes you just made and
continue sysgen, enter N.
XEROX DOCUPRINT 180 LPS SYSTEM GENERATION GUIDE
Table 4-2. Steps to perform a full sysgen (continued)
System response
* Sysgen program running *
System ID is: xxxxx
Do you want to enter a new system id?
'y' or 'n'
Enter system ID of up to 30 characters
....*....*....*....*....*....*
>
* System ID IS: xxxxx
Do you want to enter a new system id?
'y' or 'n'
This option is not supported on the DocuPrint 180 LPS.
Selection of option 15 has no effect on the LPS
Enter Ethernet Network Address
>
The base configuration and the system configuration options
are displayed followed by:
Do you wish to make any changes?
Enter 'y' or 'n'
>
Do you want to discard the changes you just
made? Enter 'y' or 'n'
>
SYSGEN AND SYSGEN-RELATED PROCEDURES
4-9