Xerox DocuPrint t 180 System Generation Manual page 60

SYSGEN AND SYSGEN-RELATED PROCEDURES
Steps for loading incremental patches
Step Action
1. Load the incremental tape on the
selected peripheral device. The system
should be at logon level 3 or higher.
2. Enter COP TAP ALL and press
<ENTER>
3. Enter @xxxx and press <ENTER>
4. Enter Y or N. Answering Y indicates that
the patches were loaded successfully.
If you answer N, you may need to
complete the procedure again.
4-32
Table 4-7 lists the steps used for loading incremental patches.
Table 4-7. Steps for loading incremental patches
System response
OS1000 Ready for Commands
Creating or replacing of files takes place followed by:
**_end of tape read
OS1000 Ready for Commands
The patches are applied, and the system displays:
PCH (patch name)
** Processing the file . . .**
*** START of (version) SST Incremental
Patches ****
**** END of (version) SST Incremental
Patches********
DID THE PATCHES APPLY WITHOUT ANY ERRORS? (Y/N)
The system deletes the files applied by the incremental tape
and displays:
SYSTEM WILL ROLLOVER IN 1 SEC
The system initializes and displays:
OS1000 - Ready for Commands hh:mm:ss
XEROX DOCUPRINT 180 LPS SYSTEM GENERATION GUIDE
hh:mm:ss
hh:mm:ss