Xerox DocuPrint t 180 System Generation Manual page 46

SYSGEN AND SYSGEN-RELATED PROCEDURES
Step Action
6. Enter Y and <ENTER> to allow the
previously entered ID to be changed. Key in
the new ID and press <ENTER>.
NOTE: When you enter no, sysgen will
continue. If you enter yes, you will be able to
change the system ID again.
7.
Enter Y or N and press <ENTER>.
8.
Enter Y or N and <ENTER>. A Y and
<ENTER> response causes the change
menu to display. Each time a change is
made, the change question is asked until an
N and <ENTER> is entered, and the sysgen
program continues.
9.
To discard the changes you just made and
continue sysgen, enter Y.
To save the changes you just made and
continue sysgen, enter N.
Enter Y and <ENTER>.
10. Enter 't' and press <ENTER>.
4-18
Table 4-4. Steps to perform an offline update sysgen using
the SYSGEN command (continued)
System response
Enter system ID of up to 30 characters
....*....*....*....*....*....*
System ID IS: xxxxx
Do you want to enter a new system id?
'y' or 'n'
Do you want to save the accounting file?
enter 'y' or 'n'
The base configuration and the system configuration
options are displayed followed by:
Do you wish to make any changes? Enter 'y'
or 'n'
>
Do you want to discard the changes you just
made? Enter 'y' or 'n'>
Is continuation of sysgen required: (y or n)
Should sysgen read from host or tape?
'h' or 't'
Reading files from tape/host is displayed.
Each file is read from the online channel or tape and placed
on the disk.
Creating file xxxxxx.yyy on drive n
xxxxxx is the system file name,
yyy is the system file type, and
n is the drive ID number that the file is
stored onto.
When sysgen completes, the following message displays:
* Tape rewinding *Sysgen process successful*
* Sysgen program off *
Enter Cmd ['C' for Menu]>
XEROX DOCUPRINT 180 LPS SYSTEM GENERATION GUIDE