Xerox DocuPrint t 180 System Generation Manual page 35

Step Action
7. Enter the option number and press
<ENTER>.
Option 1 selects all disk drives installed on
the controller.
Option 2 allows individual drives to be
selected.
Enter the drive unit number to be formatted.
If more than one drive unit is to be formatted,
enter all selected drive unit numbers
separated by commas.
Such as: >0,1,3
Then press <ENTER>.
NOTE: Only one disk's information will be
displayed at a time. Entering Y will display
the next installed disk or cause sysgen to
continue.
8. Enter Y and press <ENTER>
XEROX DOCUPRINT 180 LPS SYSTEM GENERATION GUIDE
Table 4-2. Steps to perform a full sysgen (continued)
System response
Enter the disk units to format
DP0: CONFIRM (Y/N)
The following information is displayed for the disks selected
to be formatted:
Disk characteristics (DPx:)
Manufacturer & Type: (manufacturer) (disk
type)
Unit Serial Number: nnnnn
Usable capacity: cccc MB
Number of 512-byte sectors: ssssss
Number of heads: h
Number of tracks: ttttt
Spare sectors per cylinder: s
Spare tracks per device: tt
>>>Enter "Y" to confirm that you want to
continue
>
1. Format Selected Disk(s)
2. Abort Format
Enter selection:
>
SYSGEN AND SYSGEN-RELATED PROCEDURES
4-7