Xerox DocuPrint t 180 System Generation Manual page 36

SYSGEN AND SYSGEN-RELATED PROCEDURES
Step Action
9. Enter 1 and press <ENTER>.
*******************************************************************************
* Disk unit *
*******************************************************************************
* Drive Type *
*******************************************************************************
* Disk Status *
*******************************************************************************
*Format *
* Elapsed *
* Time *
******************************************************************************
* Total *
* Usable *
* Sectors *
*******************************************************************************
10. Enter the system ID record of up to 30
characters and press <ENTER>.
11. Enter N and <ENTER>.
4-8
Table 4-2.
0 * 1
*
Selected * Not present
*
mm:ss *
*
*
*
*
Steps to perform a full sysgen (continued)
System response
Entering 1 causes the formatting of the
selected disks to occur.
The following is displayed for DP0: selected
or it is the only drive in the controller:
* 2
*
* Not Present
*
*
*
*
*
*
When formatting is completed the following is displayed:
Format/Erase program completed.
System does not have an ID record
Enter system id of up to 30 characters
....*....*....*....*....*....*
>
System ID IS: xxxxx
Do you want to enter a new system id?
'y' or 'n'
Initializing disk drive 0
Creating file BITMAP
Creating file MSBLK
Creating file BADBLK
Creating file CDLYL
ENTER CMD ('C' FOR MENU)>
XEROX DOCUPRINT 180 LPS SYSTEM GENERATION GUIDE
* 3
*
* Not present
*
*
*
*
*
*
(the ID record that
you just entered.)
.$Y$ on drive 0
.$Y$ on drive 0
.$Y$ on drive 0
.$Y$ on drive 0
*
*
*
*
*
*
*
*
*