Fuses On Rear Panel (Cpn80); Fuses Inside Cpn80; Disk Drive Module (Gem); Fuses On Cpe-Board For Disk Drive Module (Gem) - GE Voluson 730Pro Service Manual

GE M S - K
EDICAL YSTEMS
D KTI105947, R
IRECTION
5-11-2-3

Fuses on Rear Panel (CPN80)

F1 + F2: The main Input voltage is fused by two 16 Ampere fuses (rated current 16A) labeled F1 and F2.
F3: The AC Output voltage (115/230V) is fused by either:
• a 1.6 Ampere / 250V fuse for auxiliary output voltage 230 VAC
• a 3.2 Ampere / 250V fuse for auxiliary output voltage 115 VAC
F4: 16 Ampere fuse for the input voltage for the switching power supply generating the DC-Supply
voltage for the Secondary power supply inside GEF-Module
5-11-2-4

Fuses inside CPN80

F1 on CCF board: fuses the surge current limiter circuit.
NOTE: If this fuse is blown, the NTC (limiting the surge current will remain hot during system operation
and if the system is switched off/on within a few seconds the surge current could be to high.
Because of this reason Fuse F1 on CPN Rear Panel or the Hospital circuit fuse could be blown.
5-11-3

Disk Drive Module (GEM)

The check points for the drives voltages can be found at the AUX Supply connector (= GEM Power
connector) on Backpanel of GEF-Box; see:
• MO drive is supplied by +5V only
• DVD/CD drive is supplied by both +5V and +12 V
• Fan on the GEM module needs only 12 V power.
5-11-3-1

Fuses on CPE-Board for Disk Drive Module (GEM)

Description of fuses: 5A / 250V / slow-blow fuse / 5 x 20 mm
F1
+12V
RETZTECHNIK
2
EVISION
Figure 5-28 Fuses of CPN80
Figure 5-29 fuses for disk drives
Chapter 5 - Components and Functions (Theory)
DRAFT V
OLUSON
Section 7-3 "Check Points Voltages" on page
® 730P / 730P V (BT´04)
RO RO
S M
ERVICE
7-4.
F2
+5V
ANUAL
5-45