GE Voluson 730Pro Service Manual page 233

GE M S - K
EDICAL YSTEMS
D KTI105947, R
IRECTION
CtrlMvGrpRepresentations::isInWriteMode not supported for
mode nr xx
CW quant TX Frequ out of range
CW_BaseLinePos Out Of Range
CW_Gain Out Of Range
CW-hardware doesn't support
CW-HW-PRF == 0
CW-TxFrequency == 0
CW-TxPower Out Of Range
D:\\SERVICE\\ConfIndexFile is corrupt
Datatype misalignment
Delete error (Backup data could not be deleted.)
Density Out Of Range
Different software error (Backup data was made on another
system with a different software version.)
Disc full!
Display:Rect Region fails
Division by zero
done is low!
Downgrade error (Backup data was made with a software
version higher than the installed version.)
DSP - Gamma Corr - Load Data Timeout
DSP - HilbertCoeff - Load Data Timeout
DSP - Low Pass Coeff - Load Data Timeout
DSP - SetFFT_Para - Load Data Timeout
DSP - SetWMF_Koeff - Load Data Timeout
DSP/MSE:Hanning-Window Load Data Timeout
ECG_InterfaceToHW::vLookupForNewSamples() allocating
expanded buffer[xxx] for TimeStamps failed!!
Electronic user manual not installed. Please install.
End Bandwidth too big
End ET too big
End frequency too big
RETZTECHNIK
2
EVISION
Error Messages
Chapter 7 - Diagnostics/Troubleshooting
DRAFT V
OLUSON
restart the system
restart the system
press ok and save this user-setting once again
press ok and save this user-setting once again
pencil probe + CW-Hardware not available->HW problem
restart the system
restart the system
press ok and save this user-setting once again
restart the system
restart the system
check storage destination of Full Backup
(e.g., DVD/CD, insufficient rights on target Network drive,
write protection on MO or USB-drive)
press ok and save this user-setting once again
This backup cannot be restored by the user.
use a new CDR for writing data to CD
restart the system
restart the system
restart the system
load appropriate backup for installed version
restart the system
restart the system
restart the system
restart the system
restart the system
restart the system
restart the system
install Electronic User Manual (EUM) and try it again
restart the system
restart the system
restart the system
® 730P / 730P V (BT´04)
RO RO
S M
ERVICE
Actions
ANUAL
7-25