Electrical Safety; Safe Practices; Probes - GE Voluson 730Pro Service Manual

GE M S - K
EDICAL YSTEMS
D KTI105947, R
IRECTION
1-3-3 Mechanical Safety
Keep the heat venting holes on the monitor unobstructed to avoid overheating of the monitor.
CAUTION
NOTE: Special care should be taken when transporting the unit in a vehicle:
• Secure the unit in an upright position.
• Lock the wheels (brake)
• DO NOT use the Control Panel as an anchor point.
• Place the probes in their carrying case.
• Eject any DVD, CD or Magneto Optical disk (MOD) from their drive.
1-3-4

Electrical Safety

1-3-4-1

Safe Practices

To minimize shock hazard, the equipment chassis must be connected to an electrical ground.
The system is equipped with a three-conductor AC power cable. This must be plugged into an approved
electrical outlet with safety ground. If an extension cord is used with the system, make sure that the total
current rating of the system does not exceed the extension cord rating.
The power outlet used for this equipment should not be shared with other types of equipment.
Both the system power cable and the power connector meet international electrical standards.
CONNECTING A VOLUSON® 730PRO / 730PROV SCANNER TO THE WRONG
WARNING WARNING
VOLTAGE LEVEL WILL MOST LIKELY DESTROY THE SCANNER.
1-3-4-2

Probes

Follow the guidelines before connecting a probe to the scanner:
• Inspect the probe prior to each use for damage or degradation to the:
-
-
-
-
• Do not use a damaged or defective probe.
• Never immerse the probe connector or adapter into any liquid.
1-8
RETZTECHNIK
2
EVISION
(cont'd)
Housing
Cable strain relief
Lens
Seal
Section 1-3 - Safety Considerations
RAFT V
OLUSON
® 730P / 730P V (BT´04)
RO RO
S M
ERVICE ANUAL