Stop A Hardware Device; Safe To Remove Hardware - GE Voluson 730Pro Service Manual

GE M S - K
EDICAL YSTEMS
D KTI105947, R
IRECTION
3-5-10-2 Disconnection (cont'd)
To stop the external device, select it and click the STOP button.
A dialog shows which components will be stopped. To finish the process, click [OK].
Finally, a dialog shows that the device was stopped successfully.
The device can now be safely disconnected from the system.
By clicking OK, the „Unplug or Eject Hardware" dialog is active again.
Close this dialog by clicking CLOSE.
Afterwards select OK to reboot the system.
Do not connect or disconnect any external USB-devices to or from the system while
WARNING WARNING
scanning a patient! The appearing dialogs could distract you from the scan!
If the system's DVD/CD writer or (optional) MO-drive was stopped by accident, simply stop the
CAUTION
external device as well and reboot the system.
During reboot, the DVD/CD writer and the MO-drive will be installed again.
RETZTECHNIK
2
EVISION
Figure 3-20 Stop a Hardware device
Figure 3-21 Safe to Remove Hardware
Chapter 3 - Installation
DRAFT V
OLUSON
® 730P / 730P V (BT´04)
RO RO
S M
ERVICE ANUAL
3-19