Table of Contents
Advertisement
LX
k
Advanced operation
Pressing the left push-rotary knob will open the APT info sub-page, showing Bearing, Distance,
Final glide, Elevation, Airport Frequency and Runway directions.
Pressing the right push-rotary knob you will enter the 'Select airport' sub-page. Here, a
selection of airports will be shown, along with distance and bearing, as well as steering course
(relative bearing) as described earlier, with an arrow. These points can be sorted by either
Distance, Name, or ICAO code.
Choosing Name or ICAO will open up the Filter setting, where you can type the name or
code lettering. Choosing an airport will set the airport as the navigation point for the airport
navigation page.
If you have a radio transceiver connected to the LX
enabled, choosing an airport on the Airport navigation page will automatically set
the frequency of the said airport as the reserve frequency on your transceiver. For
additional info on how to enable this option, check the Connecting a Radio section
When selecting an airport, the lady from the LX
notify you over the speaker of the runway's direction and airport frequency.
Device manual
NOTE
of this manual.
NOTE
k's internal voice module will
Public
Document name:
Document revision:
k, and the proper settings
LX
KUM
R
Advertisement
Table of Contents
Need help?
Do you have a question about the LX10K and is the answer not in the manual?