Setting The 750-645 Module With Wago-I/O-Check 2 - WAGO 750-645 Manual

46 • 750-645 [2AI/2DO VIB VRMS/SPM Multi]

Setting the 750-645 Module with WAGO-I/O-CHECK 2

4.1.1.9 Setting the 750-645 Module with WAGO-I/O-CHECK 2
Select the module in node view or in navigation.
Open the parameter dialog of the selected module. To do so, execute the
command Settings in the context menu of the module (node view or
navigation).
The following dialog appears:
Fig. 4.1.1-2: Settings dialog
Note:
Before changing the parameters you should save the current values in a
parameter file. In case that the parameters are wrong, you can always fall
back on the original values. Use the SAVE and OPEN buttons in the
parameter dialog.
When opening the parameter dialog, the current parameter set of the I/O
module is read out of the module's EEPROM and displayed.
If you want to use already existing data, click the OPEN button.
In the OPEN dialog, enter a name for the parameter file and select the
directory from which the file is to be loaded. Now click on OPEN in order to
load the file from the hard disk.
You can now make the required changes.
Select the required channel in the Measuring Point group. If necessary,
change the channel name.
p064510e
WAGO-I/O-SYSTEM 750
I/O-Modules