Install The Center Rack Control - Raven AutoBoom Installation Manual

Connect the Left Press connector to Port GL on the AutoBoom valve.
3.
Connect the Right Press connector to Port GR on the AutoBoom valve.
4.
Plug the Left Solenoid, Right Solenoid, Left Prop, and Right Prop connectors into the appropriate ports of
5.
the AutoBoom valve.
Disconnect the connector from the machine's left tilt up coil.
6.
Install a boom sense adapter cable (P/N 115-0171-546) between the coil and the machine's connector.
7.
Connect boom sense adapter cables between the left tilt down, right tilt up, and right tilt down coils and their
8.
connectors.
On the harness cable, locate the Left Solenoid Sense connectors.
9.
Isolate the connector labeled Up and connect is to the left tilt up coil via the installed boom sense adapter
10.
cable.
Connect the down Left Solenoid connector to the left tilt down coil via the installed boom sense adapter
11.
cable.
Connect the Right Solenoid Sense connectors to the machine's right tilt up and right tilt down coils via the
12.
installed boom sense adapter cables.

Install the Center Rack Control

Center Rack Control
FIGURE 11.
Boom Hoist Down Coil
Locate the upper and lower boom hoist up coils near the machine's hydraulic valve.
1.
Disconnect the cable connector from the lower boom hoist up coil.
2.
Note:
This is the boom hoist up coil that points toward the machine's cab.
Install a center rack control boom sense adapter cable (P/N 115-0230-039) on the lower boom hoist up coil.
3.
Connect one of the male ends of the power splitter cable (P/N 115-0230-070) to the installed boom sense
4.
adapter cable.
Connect the female end of the power splitter cable to the cable removed from the lower boom hoist up coil.
5.
Disconnect the cable connector from the upper boom hoist up coil.
6.
Note:
Use cable ties to tie-off this connector. It is not used in the AutoBoom system.
Connect the remaining male end of the power splitter cable to the upper boom hoist up coil.
7.
Disconnect the connector from the boom hoist down coil.
8.
Install a center rack control boom sense adapter cable (P/N 115-0230-039) between the coil and the cable
9.
connector.
Manual No. 016-0230-087 Rev. E
UltraGlide
Boom Hoist Up Coils
37