Recommendations; Point Of Reference; Hydraulic Fittings - Raven AutoBoom Installation Manual

Agco rogator - 2009
Hide thumbs Also See for AutoBoom:
Table of Contents

Advertisement

Chapter 2
During the installation process, follow good safety practices. Be sure to carefully read the instructions in this
manual as you complete the installation process.

Recommendations

Raven Industries recommends the following best practices before installing or operating the AutoBoom system
for the first time, at the start of the season, or when moving the AutoBoom system to another machine:
Ensure the machine's hydraulic filters have been recently changed and there are no issues with the
machine's hydraulic system (e.g., pump issues, faulty hydraulic motors, fine metal deposits in the hydraulic
hoses, etc.).
Operate each of the machine's boom hydraulic functions (i.e., tilt, fold, center rack, tongue extension, or
other hydraulic valve functions) three times to ensure the machine's hydraulic valve is using fresh oil and
debris is flushed from the hydraulic hoses, valves, and filters.
Upon installation of the AutoBoom system, operate the boom and center rack raise/lower functions through
the machine's manual control functions first before operating them via the AutoBoom controller/field
computer to ensure the hydraulic system has been installed correctly and air is released from the system.
Raven Industries recommends the following best practices when installing the AutoBoom system.
Use part numbers to identify the parts.
Do not remove the plastic wrap from a part until it is necessary for installation.
Do not remove plastic caps from a part until it is necessary for installation.
Tools Needed
The following tools are recommended for installation of the AutoBoom system:
SAE standard-sized wrenches
Cable ties
Set of tools

Point of Reference

The instructions in this manual assume that you are standing behind the machine, looking toward the cab.

Hydraulic Fittings

This manual may reference the following types of hydraulic fittings:
SAE O-ring fittings
ORFS (O-Ring Face Seal) fittings
JIC fittings
4
RoGator 2009 AutoBoom™ Installation Manual

Advertisement

Table of Contents
loading

Table of Contents