Install The Autoboom Node; Connect The Harness To The Boom Function Controls - Raven AutoBoom Installation Manual

Chapter 3
For wiring connections made outside the cab, generously apply dielectric silicone grease (P/N 222-0000-006)
on both the male and female ends of the connectors. Application of the grease will prevent corrosion to the
pins and wires.

Install the AutoBoom Node

AutoBoom Node Installed
FIGURE 6.
Mount the AutoBoom node (P/N 063-0130-010) to the mounting plate (P/N 107-0171-619) using three 3/8"-
1.
16 UNC x 1-1/4" hex bolts (P/N 311-0054-106) and three 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).
Secure the mounting plate to the machine's center rack using two 2-9/16" W x 3-1/2" L x 3/8" thread U-bolts
2.
(P/N 107-0171-616) and four 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).
Note:
Position the node so that the cable connectors face down or to the side.
Tighten the bolts on the node connectors to secure the connections.
3.

Connect the Harness to the Boom Function Controls

Harness Cabling Connections
FIGURE 7.
Right Prop Port
Right Solenoid
Locate the Left Press and Right Press connectors on the harness cable (P/N 115-0230-045).
1.
Route the connectors to the AutoBoom valve (P/N 063-0131-113).
2.
16 RoGator 2009 AutoBoom™ Installation Manual
Left Prop
Left Solenoid