Drill Hole Patterns - Allen-Bradley Kinetix 5700 iTRAK Installation Instructions Manual

Kinetix 5700 iTRAK Power Supply and iTRAK Bus Conditioner Module

Drill Hole Patterns

This section provides hole patterns for Kinetix 5700 drives and power supplies that are mounted in zero-stack (shared-bus) configurations.
The iTRAK power supply is always mounted to the right of the Kinetix 5700 DC-bus power supply.
Calculate the left-to-right hole pattern for any Kinetix 5700 drive configuration by following these steps.
1. The first hole location is zero.
2. The second hole location is module width minus 55 mm (2.17 in.).
3. The next hole location is 55 mm (2.17 in.).
4. Repeat step 2 and step 3 for the remaining holes.
Kinetix 5700 Mounting Hole Patterns
First Mounting Hole
(typical) Upper and Lower
Mounting Hole
(all drive modules)
00.0 (0.00)
Upper Mounting Holes
32.0 (1.26)
Module Top, reference
176 (6.93)
Lower Mounting Hole
345 (13.58)
Lower Mounting Hole
420 (16.54)
Lower Mounting Hole
465 (18.31)
Lower Mounting Hole
Applies to only 2198-S160-ERS3
Single-axis Inverter
The Kinetix 5700 System Mounting Toolkit, catalog number 2198-K5700-MOUNTKIT, is available to assist you with mounting holes.
8
45.0 (1.77) See Mounting Hole Pattern Calculations
100 mm 100 mm
Wide Module Wide Module
Applies to only 2198T-W25K-ER
iTRAK Power Supply
Rockwell Automation Publication 2198T-IN001C-EN-P - October 2019
45.0 (1.77) See Mounting Hole Pattern Calculations
30.0 (1.18) See Mounting Hole Pattern Calculations
85 mm
55 mm
Wide Module
Wide Module
Applies to 2198-Pxxx Power Supplies,
2198-S086-ERS3 and 2198-S130-ERS3 Inverters,
and 2198-Dxxx-ERS3 Inverters
Ø 6.0 (0.24) Typical
Module Top
55 mm
Wide Module
Applies to only 2198-CAPMOD-DCBU
IN Extension Module
Ø 6.0 (0.24)
Typical
Dimensions are in mm (in.)
Applies to 2198-Pxxx Power Supplies
2198-Dxxx-ERS3 Inverters, and 2198-CAPMOD-2240
Capacitor Module