Table of Contents
Advertisement
Kinetix 5700 iTRAK Power Supply and iTRAK Bus Conditioner Module
Wire the iTRAK Power Supply DC Bus and Control Power Output Connectors
The iTRAK power supply uses one cable, 2198T-CHBFLS8-12AAxx, to connect to the iTRAK system. The single cable terminates at two
connectors on the iTRAK power supply: one for iTRAK control power (ICP) and one for iTRAK DC bus power (IDC). Two sets of these
connectors, referenced as A and B, are provided on the iTRAK power supply to allow using two cables for larger iTRAK systems.
ATTENTION: Make sure that the iTRAK power connections are correct when wiring the plugs and that the plug is fully engaged in the module connector.
Incorrect wiring, polarity, or loose wiring can cause an explosion or damage equipment.
You can create custom cable lengths by cutting a 2198T-CHBFLS8- 12Axx to length, remove the flying lead end and preparing new leads. see
Preparation for iTRAK Power Supply Output Power Cables on page 15
IDC and ICP Connector Wiring
IDC and ICP Connector Wiring
Description
24V iTRAK control power
DC-bus output power A and B
(1) The iTRAK control power (ICP) and iTRAK DC bus output (IDC) connections must be made using catalog number 2198T-CHBFLS8-12AAxx.
18
2198T-W25K-ER
iTRAK Power Supply
(right side view)
2198T-W25K-ER
iTRAK Power Supply
(right side view)
Connects to Terminals
Pin
Signal
ICP-1
24V+
(1)
ICP-2
24V–
GND
IDC-4
IDC-3
H
(1)
IDC-2
L
IDC-1
DC-
Rockwell Automation Publication 2198T-IN001C-EN-P - October 2019
for instructions.
iTRAK Control Power
Output Connector Plugs
(IDC A)
(ICP A)
2 1
H
L
Wire Size
mm2 (AWG)
Wire Color
White
1.5...6
(16...10)
Red
Green/Yellow
Brown
2.5...6.0
(12...10)
Black
Blue
iTRAK DC Bus
Output Connector Plugs
(IDC B)
(ICP B)
2 1
DC-
H
L
DC-
2198T-W25K-ER
iTRAK Power Supply
(bottom view)
Strip Length
Torque Value
mm (in.)
N•m (lb•in)
0.7...0.8
10.0 (0.39)
(6.1...7.0)
0.7...0.8
(6.1...7.0)
10.0 (0.39)
Cable
Advertisement
Table of Contents
