Table of Contents
Advertisement
Bus Conditioner Module Mounting Options
We recommended that you use pre-drilled and tapped holes on the iTRAK spine bars for mounting the bus conditioner module. If your system
configuration requires you to relocate the bus conditioner module here are other mounting options.
Mount Bus Conditioner Modules on an 2198T-Exxx800000, iTRAK System, 0.8 m (2.6 ft), Oval
Mount on Spine Bars (Recommended)
Bus Conditioner Module Access
Mount Below Base Plate
Bus Conditioner Module Cable Access
Mount Above Track
Mounting surface above track.
(Not shown).
Mount Bus Conditioner Modules on an Oval Multi-section Open Frame iTRAK System
Bus Conditioner Modules
Bus Conditioner Modules
Base Plate
Base Plate
Rockwell Automation Publication 2198T-IN001C-EN-P - October 2019
Kinetix 5700 iTRAK Power Supply and iTRAK Bus Conditioner Module
Dimensions are in mm (in.)
396.2
(15.60)
Minimum Opening Dimensions
Dimensions are in mm (in.)
127
(5.0)
Minimum Cable Access Dimensions
Solid Base Plate
320.6
(12.622)
5
Advertisement
Table of Contents
