Paging Pitch; Error Indicators; Beeper Pitch - Base Error; Number Of Beeps - Base Error - Honeywell Xenon 1900 User Manual

Pitch
Paging
When you press the Page button on the base or Access Point, the scan-
ners associated with that base or Access Point will begin beeping (see
Page Button on page 3-5). You can set the pitch of the paging beep for
each scanner by scanning one of the following bar codes. Default = Low.
* Low (1000 Hz)
Medium (3250 Hz)
High (4200 Hz)

Error Indicators

Beeper Pitch - Base Error

Note: This feature only applies to the CCB01-010BT base.
The CCB01-010BT base can be configured to beep at a particular pitch
when an error occurs, such as transmission problems to a host system.
The beeper pitch codes modify the pitch (frequency) of the error tone the
base emits when there is an error. Default = Low.
* Razz (250 Hz)
Medium (3250 Hz)
High (4200 Hz)

Number of Beeps - Base Error

Note: This feature only applies to the CCB01-010BT base.
3 - 11