Table of Contents
Advertisement
LED – Indicator State
The LED indicator can be programmed to have an idle state of either Off or On, with a good read blink in the opposite state.
When programmed to LED Indicator Off, the LED indicator is Off in its idle state. It blinks On for a good read, then returns
to its idle Off state. When programmed to LED Indicator On, the LED indicator is On in its idle state. It blinks Off for a
good read, then returns to its idle On state. (LED Indicator On can also be used as a power on indicator.) Default = LED
Indicator Off.
* LED Indicator Off
LED Indicator On
Number of Beeps – Good Read
The number of beeps of a good read can be programmed from 1 - 9. The same number of beeps will be applied to the
beeper and LED in response to a good read. For example, if you program this option to have five beeps, there will be five
beeps and five LED flashes in response to a good read. The beeps and LED flashes are in sync with one another. To
change the number of beeps, scan the bar code below and then scan a digit (1-9) bar code and the Save bar code on the
Programming Chart
inside the back cover of this manual. Default = 1.
Number of Good Read Beeps/LED Flashes
Number of Beeps – Error
The number of beeps and LED flashes emitted by the scanner for a bad read or error can be programmed from 1 - 9. For
example, if you program this option to have five error beeps, there will be five error beeps and five LED flashes in response
to an error. To change the number of error beeps, scan the bar code below and then scan a digit (1-9) bar code and the
Save bar code on the
Programming Chart
inside the back cover of this manual. Default = 1.
Number of Error Beeps/LED Flashes
Beeper Volume Max
Scan the following bar code to set all error and good read beeps to the maximum volume. This feature also sets the
Beeper
Pitch – Good Read
to the highest level.
Beeper Volume Max
3 - 4
Advertisement
Table of Contents
