Example For Measuring A Workpiece In Jog - Siemens SINUMERIK 828D Manual

General information on workpiece production

2.7.3 Example for measuring a workpiece in JOG

The workpiece should be setup with the Right-angled corner measuring function. The
compensation should be made in zero offset G54.
Select the Right-angled corner softkey. You can also select the cycle from the selection list
.
1
Traverse the probe to measuring point P1.
Select the zero offset, e.g. G54
When you press "NC Start", the associated measuring points P1, P2, and P3
automatically approached starting from the manually assumed preliminary position. This
means that the probe approaches the workpiece, is triggered and then returns to the start
position.
After each measuring process, the measured values can be saved in a measurement log
the measurement log can be configured in advance.
5
Once all measuring points have been approached, press Set zero offset
The corner point now corresponds to the setpoint position. The calculated offset is stored in
the zero offset.
© Siemens AG All rights reserved SINUMERIK, Manual, Mold-Making with 3- to 5-Axis Simultaneous Milling
.
2
1
2
2.7
are
3
.
4
5
3
4
47