Siemens SINUMERIK 828D Manual page 77

Important functions for 3- to 5-axis machining
Example program for swiveling in programGUIDE
Standard milling and drilling cycles are applied to swiveled machining surfaces in the following
example.
Face milling of the workpiece.
Swiveling the machining plane by X=-15 degrees and milling a circular pocket.
Swiveling by Y=-7 or +7 degrees, face grooving with milling cutter for the holes and creating
two holes at angles of +7 degrees and two holes at -7 degrees.
N100 ; Swivel the plane to the basic position
N110 CYCLE800(4,"TABLE",200000,57,0,0,0,0,0,0,0,0,0,1,,1)
N120 ; Raw part definition for simulation
N130 WORKPIECE(,,,"BOX",112,0,51,-80,-2.5,-2.5,102.5,102.5)
N140 T10 D1; T="CUTTER_D32"
N150 M06
N160 S5000 M03
N170 G0 G54 X0 Y0
N180 TRANS Z50 ;Zero offset in Z workpiece upper edge
N190 ;Face milling of workpiece in basic position
N200 CYCLE61(10,1,5,0,0,0,100,100,1,20,0,2000,32,0,1,0)
N210 ;Swiveling into the plane_1 X=-15 DEGREES
N220 CYCLE800(4,"TABLE",200000,57,0,0,50,-15,0,0,0,0,0,1,,1)
N230 ;Face milling of workpiece in Plane_1
© Siemens AG All rights reserved SINUMERIK, Manual, Mold-Making with 3- to 5-Axis Simultaneous Milling
3.4
77