Siemens SINUMERIK 828D Manual page 55

General information on workpiece production
Determining the tool radius:
The measuring process is performed with rotating spindle and the setpoint - actual value
deviation is entered optionally into the radius wear
Select the radius as measured value
for tool breakage.
Assign parameters to the measuring process
Single cutting edge measurement (as of SW 4.5)
© Siemens AG All rights reserved SINUMERIK, Manual, Mold-Making with 3- to 5-Axis Simultaneous Milling
1
. Each tooth can be individually measured to check
2
.
3
3
The single cutting edge measurement
remeasuring (compensation in the wear) and initial
measuring (compensation in the geometry). Milling tools
4 with up to 100 cutting edges can be measured.
The cycle checks whether the measured values of all cutting
edges are within a defined tolerance range. If the measured
values are outside the tolerance range, an alarm is output.
If the measured value of the longest cutting edge is within
the tolerance range, this is entered in the tool management.
2.8
.
2
1
can be used for
4
55