Siemens SINUMERIK 828D Manual page 32
Milling with sinumerik mold-making with 3- to 5-axis simultaneous milling
Hide thumbs
Also See for SINUMERIK 828D:
- Function manual (1799 pages) ,
- Commissioning manual (1167 pages) ,
- Operating manual (926 pages)
Table of Contents
Advertisement
2.3
32
General information on workpiece production
Whereby:
CYLCE832 must be called immediately before the mold-making program.
After selection of CYCLE832, only motion commands (G0, G1, G2, G3) should be
programmed.
Manufacturer-specific subprograms, e.g. for tool change or swivel, can overwrite settings of
the CYCLE832 and must be programmed outside the CYCLE832 selection and deselection.
Programming overview
T1 D1 M6
...
CYCLE800(4,"HEAD",200000,57,0,0,0,0,0,0,0,0,0,1,,1) Settings,
...
CYCLE832 (0.1,_ROUGH,1)
...G1 X-1.45345 Y0.67878 F10000...
CYCLE832(0,_OFF,1)
...
CYCLE800()
...
Example, NC commands in the 5-axis program sequence
...
CYCLE800()
TRAFOOF
T="CUTTER_10"
M6
S15061 M3
CYCLE800(0,"TABLE",100000,27,0,0,0,288.079,0,-10.196,0,0,0,-1,0,1)
G00 X-13.532 Y-24.856 M03
TRAORI
ORIWKS ORIAXES
G54
TOFFL=0
TOFFR=0
CYCLE800()
CYCLE832(0.05,_TOP_SURFACE_SMOOTH_ON+_ORI_SEMIFIN,1)
...
© Siemens AG All rights reserved SINUMERIK, Manual, Mold-Making with 3- to 5-Axis Simultaneous Milling
Description
Tool change
e.g. swivel
Select CYCLE832
Mold-making program
Deselect CYCLE832
Deselect CYCLE800
Advertisement
Table of Contents
