Siemens SINUMERIK 828D Manual page 148

6.2
Example start program
148
Complex free-form surfaces
Example program code
The NC programs for producing the manta ray involve a number of roughing, semi-finishing, and
finishing strategies. The key components of the NC programs are illustrated below on the basis
of the start program and a roughing program.
Within the start program, it is sometimes a good idea to make all the settings in the geometry
subprograms, particularly as far as individual part production and the test phase are concerned.
The start program will only call those subprograms that contain all the specifications, such as
tool, CYCLE832. This is particularly helpful in cases where the postprocessor is perfectly attuned
to the SINUMERIK system and all higher-order functions have already been integrated. In test
mode, it is advisable to execute the subprograms individually; jump labels can be used within the
start program, for example, for the purpose of launching the required subprogram.
N100 G90 G17 G54
N105 ORIWKS ORIAXES
N110 GOTOF _ROUGH_01
N120 ;GOTOF _ROUGH_02
...
N210 ;GOTOF _FINISH_05
N220 _ROUGH_01:
N230 EXTCALL "ROUGH_01"
N240 STOPRE
N250 M00
N280 ...
N360 _FINISH_05:
N370 EXTCALL "FINISH_05"
N380 STOPRE
N390 M00
N400 M30
© Siemens AG All rights reserved SINUMERIK, Manual, Mold-Making with 3- to 5-Axis Simultaneous Milling
; Absolute dimension specification, select
; working plane and zero offset
; Workpiece coordinate system, axis
interpolation
; Subprogram jump label for calling roughing with
; the ROUGH_01.MPF program.
; This program is explained in greater detail on
; the next page.
; Unused jump labels are
; commented out for the test phase.
;
;
; Jump destination for GOTOF
; Call for roughing 01 subprogram
; Preprocessing memory stopped, i.e. the
; subsequent NC blocks will only be read-in once
; all the previous NC blocks have been executed.
; Program stop
;
; Subprogram call for the last finishing program
;
;
; End of program