Action List - Siemens SINUMERIK 802S Diagnostics Manual

1 Alarms
1.4

Action List

No./Name
1. INIT
2. RESET
3. RESET_INITBLOCK
4. PROG_END
5. MODESWITCHTOA-
PROGMODE
6. MODESWITCHTOSAVE-MODE
1-96
Explanation
Carry out INI
phase (the tasks
are initialized
after Power On)
t RESET
(VDI signal: after
Reset, mode
group reset
('BAG RESET')
or Power On)
Activate Reset
init blocks
(VDI signal: after
Reset)
Carry out
RESET, end of
program has
been detected
(NC block with
M30)
Changing from 1. the channel is active (program
operating mode running, block search, loading of
to program mode machine data)
MDA or Auto-
matic 2. the program has already been
(VDI signal: started in another program mode.
BAG) 3. a channel has left the mode group
because of an interrupt.
4. Overstore or Digitalize has been
selected.
Automatic
change from an
internal operating
mode to the
externally set
operating mode
(During
TEACH_IN, it is
tried after each
stop to switch
over from the
internal operating
mode
"AUTOMATIC,
MDA" to
TEACH_IN)
6FC5598-3AA20-0BP2
Not allowed if
⇒ Press RESET to abort the
⇒ Abort program using the
⇒ Press RESET to abort the
⇒ Deselect Overstore, Digitalize
© Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
01.02
Remedy
program or stop program (not
during block search or ma-
chine data loading)
Reset key
program or wait until interrupt
is completed.