Siemens SINUMERIK 802S Diagnostics Manual page 32

1 Alarms
Response
Remedy
Program continua-
tion by
10 910
Explanation
Response
Remedy
Program continua-
tion by
10 911
Explanation
Response
Remedy
Program continua-
tion by
10 930
Explanation
Response
Remedy
1-32
Alarm display.
Interface signals are set.
NC Start inhibited.
Program the constant cutting speed under S in [m/min] or deselect function
G96. For example, the preceding feed remains when G97 is active but the
spindle goes on rotating with the current speed.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 excessive velocity of one path axis
%1 = Channel number
%2 = Block number, label
When transformation is selected, an extreme velocity rise in one or several
axes occurs, for example, since the path runs in the vicinity of the pole.
Alarm display.
Division of the NC block into several blocks (e.g. 3) so that the path section
with the chamfer is as small as possible and therefore short. The remaining
blocks will then be traversed with the programmed velocity.
Press the Clear key to clear the alarm. No further operation required.
Channel %1 block %2 transformation prohibits to traverse the pole.
%1 = Channel number
%2 = Block number, label
The given curve leads through the pole of the transformation.
Alarm display.
Interface signals are set.
NC Start inhibited.
Modify part program.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 interpolation type not allowed in stock removal
contour
%1 = Channel number
%2 = Block number, label
The contour of the stock removal cycle (LCYC 95) contains path commands
other than G00, G01, G02 or G03. The contour program may only contain
contour elements built from these G functions (i.e. no thread blocks, no G05,
etc.).
Alarm display.
Interface signals are set.
NC Start inhibited.
Program only path elements in the contour program, which consist of straight
lines and circular arcs.
6FC5598-3AA20-0BP2 © Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
01.02