Siemens SINUMERIK 802S Diagnostics Manual page 91

01.02
Program continua-
tion by
61 602
Source (Cycle)
Response
Remedy
Program continua-
tion by
61 603
Source (Cycle)
Response
Remedy
Program continua-
tion by
61 605
Explanation
Response
Remedy
Program continua-
tion by
61 606
Explanation
Response
Remedy
Program continua-
tion by
61 607
Source (Cycle)
Response
Remedy
Program continua-
tion by
61 608
Source (Cycle)
Response
© Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
Press the RESET key to clear the alarm. Restart part program.
Tool width incorrectly defined
LCYC93
Block preparation in NC is aborted
The tool width (parameter R107) does not match with the programmed recess
shape.
Press the RESET key to clear the alarm. Restart part program.
Recess type incorrectly defined
LCYC93
Block preparation in NC is aborted
The recess form is incorrectly programmed.
Press the RESET key to clear the alarm. Restart part program.
Contour incorrectly defined
LCYC95
Block preparation in NC is aborted.
Contour contains undercut elements that must be removed.
Press the RESET key to clear the alarm. Restart part program.
Error during contour preparation
LCYC95
Block preparation in NC is aborted.
Check contour subroutine.
Check machining parameter (R105).
Press the RESET key to clear the alarm. Restart part program.
Starting point incorrectly defined
LCYC95
Block preparation in NC is aborted
The start point reached prior to the cycle call is not outside the square de-
scribed by the contour subroutine.
Press the RESET key to clear the alarm. Restart part program.
Indirect tool point direction programmed
LCYC94
Block preparation in NC is aborted
6FC5598-3AA20-0BP2
1 Alarms
1-91