Siemens SINUMERIK 802S Diagnostics Manual page 28

1 Alarms
10 762
Explanation
Response
Remedy
Program continua-
tion by
10 763
Explanation
Response
Remedy
Program continua-
tion by
10 764
Explanation
Response
Remedy
Program continua-
tion by
1-28
Channel %1 block %2 too many empty blocks between two traversing
blocks with active tool radius compensation
%1 = Channel number
%2 = Block number, label
The maximum admissible number of empty blocks is limited
Alarm display.
Interface signals are set.
NC Start inhibited.
1. Modify part program:
2. Check whether SBL2 is selected. When SBL2 is active, a block from each
part program line is generated resulting in that the permissible number of
empty blocks between two traversing blocks can be exceeded.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 path component of the block in the compensation
plane becomes zero.
%1 = Channel number
%2 = Block number, label
Because of the collision monitoring with tool radius compensation, the path
component of the block in the compensation level becomes zero. If no move-
ment information perpendicular to the compensation level is contained in the
original block, the block is skipped.
Alarm display.
•
The behavior at narrow places which cannot be machined with the active
tool is correct.
•
Modify part program
•
If necessary use a tool with smaller radius
Press the Clear key to clear the alarm. No further operation required.
Channel %1 block %2 discontinuous path with active tool radius compen-
sation
%1 = Channel number
%2 = Block number, label
This alarm occurs when tool radius compensation is active and the start point
used for the calculation of the compensation is not equal to the end point of the
preceding block.
Alarm display.
Interface signals are set.
NC Start inhibited.
- Modify part program.
Press the RESET key to clear the alarm. Restart part program.
6FC5598-3AA20-0BP2 © Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
01.02