Siemens SINUMERIK 802S Diagnostics Manual page 53

01.02
15 370
Explanation
Response
Remedy
Program continua-
tion by
15 400
Explanation
Response
Remedy
Program continua-
tion by
15 410
Explanation
Response
Remedy
Program continua-
tion by
© Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
Channel %1 target of block search not found
%1 = Channel number
An invalid search target (e.g. negative block number) has been specified for
block search.
Alarm display.
Check specified block number, label or string. Repeat your entry with the cor-
rect search target.
Press the Clear key to clear the alarm. No further operation required.
Channel %1 block %2 selected initial ini file does not exist
%1 = Channel number
%2 = Block number, label
The operator has selected an INI block for a read, write or processing function,
which:
1. does not exist in the NCK area, or
2. which does not have the required protection level required to execute the
function.
Alarm display.
Check whether the selected INI block is stored in the file system of the NCK.
The protection level must be at least the same (or higher) than the protection
level defined when creating the file for the read, write or processing function.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 initialization file contains invalid M function
%1 = Channel number
%2 = Block number, label
The only M function permitted in an Init block is the end of program with
M02, M17 or M30.
Alarm display.
Interface signals are set.
Interpreter stop.
NC Start inhibited.
Remove all M functions from the Init block (except for the end-of-block char-
acter).
Init blocks may only contain value assignments (and global data definitions if
not defined once more in a program executed later), but no movement or syn-
chronous actions.
Press the RESET key to clear the alarm. Restart part program.
6FC5598-3AA20-0BP2
1 Alarms
1-53