Siemens SINUMERIK 802S Diagnostics Manual page 59

01.02
Program continua-
tion by
16 763
Explanation
Response
Remedy
Program continua-
tion by
16 770
Explanation
Response
Remedy
Program continua-
tion by
16 830
Explanation
Response
Remedy
Program continua-
tion by
© Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 axis %3 programmed speed is illegal (zero or nega-
tive)
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
A speed (S value) with zero value or negative value has been programmed.
Alarm display.
Interface signals are set.
Interpreter stop.
NC Start inhibited.
The programmed speed (S value) must be positive. Depending on the particular
application, zero can also be accepted (e.g. G25 S0).
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 axis %3 encoder missing
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
A position was programmed for the axis which requires a measuring system.
Acc. to MD 30 200 NUM_ENCS, this machine axis has no measuring system.
Alarm display.
Interface signals are set.
Interpreter stop.
NC Start inhibited.
Remove the respective function (e.g. SPOS) from the part program, or enter an
existing measuring system in MD 30 200 NUM_ENCS.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 invalid position for axis/spindle %3 programmed
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
A position for the modulo axis has been programmed out of the range 0 -
359.999.
Alarm display.
Interface signals are set.
Interpreter stop.
NC Start inhibited.
Program a position within the range 0 - 359.999.
Press the RESET key to clear the alarm. Restart part program.
6FC5598-3AA20-0BP2
1 Alarms
1-59