Siemens SINUMERIK 802S Diagnostics Manual page 24

1 Alarms
Program continua-
tion by
10 730
Explanation
Response
Remedy
Program continua-
tion by
10 750
Explanation
Response
Remedy
Program continua-
tion by
1-24
Check the axis-specific interface signals: "2nd software limit switch
plus/minus" (V 380x1000.2 and .3) and make sure that the 2nd software limit
switch is selected.
Check the currently active zero offsets via the current frame.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %3 axis %2 work area limitation %4
%1 = Channel number
%2 = Axis name, spindle number
%3 = Block number, label
%4 = String (+ or -)
During block preparation, it has been detected that the programmed path car-
ries the axes across the work area limitation.
Alarm display.
Interface signals are set.
Include correction block in reorganization.
NC Start inhibited.
Modify the part program.
Change the work area limitation in the setting data.
Press the N C START to clear the alarm and to continue the program.
Channel %1 block %2 tool radius compensation activated without tool no.
%1 = Channel number
%2 = Block number, label
A tool T.. must be selected so that the control system can consider the associ-
ated compensation values.
Each tool (T number) is automatically assigned a compensation data block
(D1) containing the compensation data. A tool can be assigned max. 9 compen-
sation data blocks by specifying the desired data block with the D number.
(D1 - D9).
The tool radius compensation (TRC) will be included in calculation if the
function G41 or G42 is programmed. The compensation values are contained
in the parameter P6 (geometry value) and P15 (wear value) of the active com-
pensation data block D x .
Alarm display.
Interface signals are set.
NC Start inhibited.
Program a tool No. under address T.. with G41/G42 before calling the tool
radius compensation.
Press the RESET key to clear the alarm. Restart part program.
6FC5598-3AA20-0BP2 © Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
01.02