Siemens SINUMERIK 802S Diagnostics Manual page 49

01.02
Remedy
Program continua-
tion by
14 840
Explanation
Response
Remedy
Program continua-
tion by
14 900
Explanation
Response
Remedy
Program continua-
tion by
14 910
Explanation
Response
Remedy
© Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
Remove G97 from the displayed block and program the correct feed type
(G94, G95 or G96) for the next following machining section.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 value for constant cutting speed out of range
%1 = Channel number
%2 = Block number, label
The programmed cutting speed is out of the input range.
Metric input range:
Inch input range:
Alarm display.
Interface signals are set.
Interpreter stop.
NC Start inhibited.
Program the cutting speed under address S within the permissible value range.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 use either center point or end point programming
%1 = Channel number
%2 = Block number, label
When the circle was programmed using the opening angle, the circle center
point and, in addition, the circle end point has been programmed, too. The
circle is thus 'overdetermined'. Only one of the two points is permitted.
Alarm display.
Interface signals are set.
Interpreter stop.
NC Start inhibited.
Select that programming variant at which the dimensions can be taken over
from the workpiece drawing without doubts (in order to avoid errors in calcu-
lation).
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2 invalid angle of aperture for programmed circle
%1 = Channel number
%2 = Block number, label
When programming the circle using the opening angle, a negative opening
angle or an opening angle >= 360 degrees has been programmed.
Alarm display.
Interface signals are set.
Interpreter stop.
NC Start inhibited.
Program the opening angle within the permitted value range of 0.0001 -
359.9999 [degrees].
0.01 to 9 999.99 [m/min]
0.1 to 99 999.99 [inch/min]
6FC5598-3AA20-0BP2
1 Alarms
1-49