Siemens SINUMERIK 802S Diagnostics Manual page 92

1 Alarms
Remedy
Program continua-
tion by
61 609
Source (Cycle)
Response
Remedy
Program continua-
tion by
61 610
Source (Cycle)
Response
Remedy
Program continua-
tion by
62 000
Explanation
Response
Remedy
Program continua-
tion by
62 101
Explanation
Response
Remedy
Program continua-
tion by
1-92
An edge position 1 .. 4 matching with the recess shape must be programmed.
Press the RESET key to clear the alarm. Restart part program.
Shape incorrectly defined
LCYC94
Block preparation in NC is aborted
Check parameters for the recess shape.
Press the RESET key to clear the alarm. Restart part program.
Infeed depth not programmed
LCYC95
Block preparation in NC is aborted
The parameter R108>0 for the infeed depth must be programmed for roughing.
Press the RESET key to clear the alarm. Restart part program.
Channel %1 block %2
%1 = Channel number
%2 = Block number, label
%3 = Text index for cycle alarms
See SIEMENS Cycle Description
Alarm display.
See SIEMENS Cycle Description
Press the Clear key to clear the alarm. No further operation required.
Finishing allowance has been reduced to possible value
LCYC75
Block preparation in NC is aborted.
The cutter diameter is larger than the pocket or groove width minus the finish-
ing allowance.
Either use a smaller cutter, or
reduce the finishing allowance, or
enlarge the pocket/groove width.
Press the RESET key to clear the alarm. Restart part program.
6FC5598-3AA20-0BP2 © Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
01.02