Siemens SINUMERIK 802S Diagnostics Manual page 36

1 Alarms
12 080
Explanation
Response
Remedy
Program continua-
tion by
12 110
Explanation
Response
Remedy
Program continua-
tion by
12 120
Explanation
Response
Remedy
Program continua-
tion by
1-36
Channel %1 block %2 syntax error in text %3
%1 = Channel number
%2 = Block number, label
%3 = Source text area
The grammar of the block has been violated at the displayed text position. The
exact error cause cannot be specified more exactly, since there are too many
possible error causes.
Example 1:
N10 IF GOTOF ..
Example 2:
N10 R-50 =12
Alarm display.
Interface signals are set.
Corrected block.
Analyze block and correct it using the Programming Instructions.
Press NC START to clear the alarm and continue program execution.
Channel %1 block %2 syntax cannot be interpreted
%1 = Channel number
%2 = Block number, label
The addresses programmed in the block are not allowed with the valid syntax-
defining G function.
Example:
G1 I10 X20 Y30 F1000; No interpolation parameter may be programmed in
the linear block.
Alarm display.
Interface signals are set.
Check block structure and correct it as required by the program.
Press NC START to clear the alarm and continue program execution.
Channel %1 block %2 Write special G function in separate block
%1 = Channel number
%2 = Block number, label
The G function programmed in this block must be written in a separate block.
No general addresses are allowed in the same block. These G functions are:
G25, G26 Spindle speed limitation
Example:
G4 F1000 M100; No M function is allowed in the G4 block.
Alarm display.
Interface signals are set.
Program the G function in a separate block.
Press NC START to clear the alarm and continue program execution.
6FC5598-3AA20-0BP2
; The condition for the jump is missing!
; Faulty arithmetic parameter number
© Siemens AG 2002 All Rights Reserved
01.02
SINUMERIK 802S/802C (DG)