Siemens SINUMERIK 802S Diagnostics Manual page 97

01.02
No./Name
7. MODESWITCHTOHAND-MODE
8. OVERSTOREON
9. OVERSTOREOFF
10. SYNCHWITHREPOS
11. INTERRUPT
12. INTERRUPTFASTLIFT-OFF
13. INTERRUPTBLSYNC
© Siemens AG 2002 All Rights Reserved
SINUMERIK 802S/802C (DG)
Explanation
Changing from 1. too high nesting depth:
the operating Various events (e.g. interrupt) may
mode to a man- interrupt execution of the current
ual mode program. Depending on the par-
(VDI signal: ticular event, ASUP programs are
JOG, activated.
TEACH_IN, These ASUP programs can be
REF) aborted in the same manner as
the user program. For memory
reasons, any nesting depth of the
ASUP programs is not possible.
2. the channel is active (program
running, block search, loading of
machine data)
3. a channel has left the mode group
because of an interrupt.
4. Overstore or Digitalize is selected.
Selection of
Overstore mode
(PI command).
Deselection of
Overstore mode
(PI command).
Synchronize
advance and
main part of
program, e.g.
switch on open-
loop axis control
(VDI signal:
follow-up mode)
Carry out user 1. the channel is active due to block
interrupt "ASUP" search or machine data loading
(VDI signal:
digital-analog 2. the channel is stopped and the
interface, ASUP Asup "ASUP_START_MASK"
interface). must be started and the current
block cannot be reorganized.
3. Digitalize is selected
4. reference-point approach has not
yet been carried out
5. the current block in which program
execution has been stopped can-
not be reorganized, since decel-
eration is carried out aver several
blocks.
Carry out user See 11
interrupt "ASUP"
with quick lifting
(VDI signal:
digital-analog
interface)
Carry out user See 11
interrupt at end of
block
(VDI signal:
digital-analog
interface)
6FC5598-3AA20-0BP2
Not allowed if
⇒ Press RESET to abort the
⇒ Press RESET to abort the
⇒ Press RESET to abort the
⇒ Deselect Overstore / Digital-
⇒ Wait until block search or
⇒ Activate block change as long
⇒ Deselect Digitalize
⇒ Carry out reference-point
⇒ Abort program
1 Alarms
Remedy
program
program or stop the program
(not during block search or
machine data loading)
program or wait until the inter-
rupt is completed.
ize
machine data loading is com-
pleted, or press the RESET
key to abort the program
as the NC block can be reor-
ganized.
approach or ignore this condi-
tion by setting the machine
data "ASUP_START_MASK".
1-97