Change The Ip Settings - Digi ConnectPort LTS Series User Manual

ConnectPort LTS LCD interface
IP settings #1: Sets IP mode, IP address, subnet mask, and the default gateway of network
n
interface #1.
IP settings #2: Sets IP mode, IP address, subnet mask, and the default gateway of network
n
interface #2.
Host name: Specifies the host name of the device.
n
DNS: Specifies the primary DNS of the device.
n
Note You can only set IPv4 mode. You cannot configure IPv6 using the LCD interface.

Change the IP settings

You can change the IP mode, as well as the IP address, subnet mask, and default gateway settings.
To set the IP Mode:
1. From the LCD main menu, select CONFIGURATION.
2. Select either IP SETTINGS #1 or IP SETTINGS #2. The following IP menu appears:
3. Select IP MODE and then select one of the following options:
DISABLE: Disable this Ethernet interface.
n
STATIC IP: Set the IP mode to STATIC. If you set the IP address mode to STATIC, you can set
n
the static IP address, subnet mask, and gateway addresses.
DHCP: Set the IP mode to DHCP.
n
To change the IP address:
1. Select IP ADDRESS from the IP menu.
2. Select the IP address that you want to change.
Digi ConnectPort LTS User Guide
Configuring the ConnectPort LTS using the LCD interface
148