Fcc Certifications And Regulatory Information (Usa Only); Fcc Part 15 Class B; Radio Frequency Interface (Rfi) (Fcc 15.105); Labeling Requirements Fcc (15.19) - Digi ConnectPort LTS Series User Manual

ConnectPort LTS regulatory information and
certifications

FCC certifications and regulatory information (USA only)

FCC Part 15 Class B

n

Radio Frequency Interface (RFI) (FCC 15.105)

n

Labeling Requirements FCC (15.19)

n
FCC Part 15 Class B
These devices comply with the standards cited in this section:
ConnectPort LTS 16
n
ConnectPort LTS 32
n
Radio Frequency Interface (RFI) (FCC 15.105)
This device has been tested and found to comply with the limits for Class B digital devices pursuant to
Part 15 Subpart B, of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential environment. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try and correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
n
Increase the separation between the equipment and receiver.
n
Connect the equipment into an outlet on a circuit different from that to which the receiver is
n
connected.
Consult the dealer or an experienced radio/TV technician for help.
n
Labeling Requirements FCC (15.19)
This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
If the FCC ID is not visible when installed inside another device, then the outside of the device into
which the module is installed must also display a label referring to the enclosed module FCC ID.
Modifications (FCC 15.21)
Changes or modifications to this equipment not expressly approved by Digi may void the user's
authority to operate this equipment.

Industry Canada (IC) certifications

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of the Canadian Department of
Communications.
Digi ConnectPort LTS User Guide
FCC certifications and regulatory information (USA
only)
160