Administration - Digi ConnectPort LTS Series User Manual

Configure and manage the device using the ConnectPort LTS command line interface

Administration

You can issue commands from the command-line interface to administer ConnectPort LTS products.
The following table displays several administration tasks and the commands used to perform them.
See the Digi Connect® Family Command Reference for more complete command descriptions.
Administrative task
Backup/restore a configuration from a
TFTP server on the network
Update firmware
Reset configuration to factory defaults revert
Display system information and
statistics
Reboot the device
Enable/disable network services
Configure device server for tracing and
display tracing information
Digi ConnectPort LTS User Guide
Command
backup to=serveripaddress[:filename]
boot
To update the firmware:
1. Telnet or ssh to the Digi device command-line
interface using a telnet/ssh application.
2. A login prompt appears. The default user name is
root and the unique default password is printed on
the device label. If the password is not on the device
label, the default password is dbps. If neither of the
defaults work, the password may have been
updated. Contact your system administrator.
3. If you are at the bash shell, type configshell to get
to the config shell.
4. Issue the boot load command:
#> boot load= tftp-server-ip : filename
Replace tftp-server-ip with the IP address of the
TFTP server that contains the firmware, and
replace filename with the name of the file to upload.
or
boot action=factory
info
boot
set service
set trace
Administration
141