Set Alarm; Set Autoconnect; Set Buffer And Display Buffers; Set Group - Digi ConnectPort LTS Series User Manual

Configure and manage the device using the ConnectPort LTS
command line interface

set alarm

Use the set alarm command to display alarm settings, including conditions that trigger alarms, and
how alarms are sent. You can configure alarms to be sent as either an email message, an SNMP trap,
or both. You can configure the alarms as needed.

set autoconnect

Use the set autoconnect command to configure the autoconnection behaviors for serial port
connections.

set buffer and display buffers

Use the set buffer command to configure buffering parameters on a port and display the current port
buffer configuration. The display buffers command displays the contents of a port buffer, or
transfers the port-buffer contents to a server running Trivial File Transfer Protocol (TFTP).

set group

Use the set group command to configure create, establish, update, or remove group attributes.

set host

Use the set host command to configure the host name for the Digi device.

set ippool

Use the IP pool command to configure the IP pool for the PPP connection.

set lcd

Use the set lcd command to configure the LCD.

set modem

Use the set modem command to configure the modem profile.

set network

Use the set network command to configure the network options.

set nfs

Use the set nfs command to configure NFS.

set permissions

Use the set permissions command to configure the user permissions for various services and
command-line interface commands.
Digi ConnectPort LTS User Guide
Management through the command line
interface
137