System Configuration - Digi ConnectPort LTS Series User Manual

Configure the device using the ConnectPort LTS web interface
Send alarms based on serial data pattern matching: Click this radio button to specify that
n
this alarm is sent when the specified serial data pattern is detected. Then specify the following:
Serial Port: The serial port to monitor for the data pattern. This field appears for devices
l
where more than one serial port is available.
Pattern: When the serial port receives this data pattern it sends an alarm. You can include
l
special characters such as carriage return carriage return (\r) and new line (\n) in the data
pattern.
Alarm Destinations
Use the Alarm Destinations page to define how alarm notifications are sent, either as an email
message or an SNMP trap, or both, and where the alarm notification is sent.
Alarm Type: Specify the alarm type to send. Your options are as follows:
n
[none|email|snmptrap|all]
Alarm Description: The text to include in the Subject: lien of the alarm-notification email or
n
SNMP traps description.
Send SNMP trap to the following destination when alarm occurs: Specifies whether to
n
send the alarm as an SNMP trap. To send alarms as SNMP traps, you must set the Alarm Type
to snmptrap and specify the IP address of the destination for the SNMP traps in the SNMP
settings.
To configure an alarm notification to be sent as both an email message and an SNMP trap:
1. Select both Send E-Mail and Send SNMP trap check boxes.
2. Click Apply to apply changes to alarm settings and return to the Alarms Configuration page.
Configure alarm conditions
To configure an alarm:
1. Select Configuration > Alarms.
2. To enable or disable an alarm, select or clear the Enable check box next to the alarm.
3. Click the alarm under the Alarm column that you want to configure.
4. Configure the fields in the following sections:
Alarm Conditions: These condition specify the conditions on which the alarm is based,
n
such as serial data pattern matching or data usage.
Alarm Destinations: These conditions specify how the alarm is sent, either as an email
n
message or an SNMP trap, or both, and where the alarm is sent.
5. Click Apply to save your changes.

System Configuration

Use the System Configuration page to configure device identity and description information, date and
time settings, and settings for Simple Network Management Protocol (SNMP).
Digi ConnectPort LTS User Guide
Configuration through the web interface
79