Newpass; Reconnect; Rlogin; Send - Digi ConnectPort LTS Series User Manual

Configure and manage the device using the ConnectPort LTS
command line interface
Serial statistics. The info serial command displays the following information:
n
Number of bytes received and transmitted
l
Signal changes
l
FIFO and buffer overruns
l
Framing and parity errors
l
Breaks detected
l
TCP statistics. The info tcp command displays the following information:
n
The number of segments received or sent
l
The number of active and passive opens
l
The number of bad segments received
l
The number of failed connection attempts
l
The number of segments retransmitted
l
The number of established connections that were reset
l
UDP statistics. The info udp command displays the following information:
n
The number of datagrams received or sent
l
The number of bad datagrams received
l
The number of received datagrams that were discarded because the specified port was
l
invalid
ZigBee statistics. The info zigbee_sockets command displays the following information:
n
The number of frames received or sent
l
The number of bad frames received or sent
l
The number of bytes received or sent
l
The number of received bytes dropped or truncated
l

newpass

Use the newpass command to issue a new password to a user.

reconnect

Use the reconnect command to reestablish a connection opened by a connect, rlogin, or telnet
command. By default, the reconnect command reestablishes the connection to the last active
session.

rlogin

Use the rlogin command to sign in to a remote system.

send

Use the send command to send a telnet control command, such as break, abort output, are you there,
escape, or interrupt process, to the last active telnet session.
Digi ConnectPort LTS User Guide
Management through the command line
interface
136