Restore Connectport Lts To Factory Default Settings - Digi ConnectPort LTS Series User Manual

ConnectPort LTS disaster recovery

Restore ConnectPort LTS to Factory Default Settings

To restore the ConnectPort LTS to the factory default configuration settings, use a TFTP or BOOTP
server. To use the Bios menu to flash new firmware and/or new BIOS code revision:
1. Connect the console port on the rear panel of the Digi ConnectPort LTS unit to a serial port on
a workstation. Use the supplied RJ45/DB9F console adapter and an Ethernet cable.
2. Set up a terminal emulation program such as HyperTerminal. Use the following port
parameters:
bps=9600
n
data bits=8
n
parity=none
n
stop bits=1
n
flow control=none
n
3. Reboot or power on the ConnectPort LTS unit.
4. Press the ESC key within three seconds of applying power to the device. The following screen
appears. Use the ESC key to return to a previous menu screen, and then press the Enter key to
refresh the menu screen.
5. Choose Firmware upgrade by entering 3. The following screen appears.
Digi ConnectPort LTS User Guide
Restore ConnectPort LTS to Factory Default Settings
156