Serial Ports Configuration - Digi ConnectPort LTS Series User Manual

Configure the device using the ConnectPort LTS web interface
networks. You can filter devices on a single IP address or restrict device to a group of devices using a
subnet mask that only allows specific networks to access to the device.
CAUTION! Plan and review your IP filtering settings before applying them. If the settings
are incorrect, the Digi device will be inaccessible from the network.
The settings for IP Filtering Settings include:
Interface: The name of the network interface where the packet originated.
n
Option: Determines the rule that will be applied to the specified IP address/mask or its
n
inverse.
IP address/Mask: Specifies the host range by entering the base host IP address followed by a
n
forward slash (/) and subnet mask.
Protocol: The type of protocol this port will accept or drop.
n
Port: A TCP/IP port on the Digi device that other hosts will access.
n
Chain: Determines whether or not hosts can access the port.
n

Serial ports configuration

Use the Serial Ports Configuration page to establish a port profile for each serial port on the
ConnectPort LTS product. The Serial Ports Configuration page includes the currently selected port
profile for the serial port, detailed configuration settings for the serial port, dependent on the port
profile selected, and links to basic and advanced serial settings.
The Serial Port Configuration page includes:
Port Group Settings: This pane allows you to create one or more port groups and assign ports
n
to each port group. See
Port Settings: This pane lists the available ports and allows you to configure or copy selected
n
ports. See Port Settings
Port Group Settings
You can create port groups to send data to multiple ports. Instead of sending data to individual serial
ports, you can send data to all ports in a group simultaneously through a port in a group. If you select
an additional option, you can also see the data from multiple ports in the same group from a terminal
connected to the one of serial ports in the group.
To configure a port group, you must create a port group first and then select ports to be associated
with this group. You can create a maximum number of 16 port groups and a port cannot be associated
with multiple groups. When you select ports to be associated with a group you can also configure
following settings:
No.: The group number.
n
Group name: The name of the group.
n
Ports: Lists the ports associated with the group.
n
When you click Add, the following settings appear:
Group name: The name of the group.
n
Check all/Uncheck all: Select or clear the check boxes for all ports.
n
Digi ConnectPort LTS User Guide
Port Group Settings for more information.
for more information.
Configuration through the web interface
52