Drive-Cliq Interfaces X100 To X103 - Siemens SIMATIC S7-1500 System Manual

Connecting

6.8 DRIVE-CLiQ interfaces X100 to X103

Additional information
Additional information on the pin assignment of interfaces X122, X132, X142 can be found in
the SIMATIC Drive Controller manual
(https://support.industry.siemens.com/cs/ww/en/view/109766666).
6.8 DRIVE-CLiQ interfaces X100 to X103
Properties of the DRIVE-CLiQ interfaces
The SIMATIC Drive Controller has four DRIVE-CLiQ interfaces. The components of the
SINAMICS S120 drive system including the motors and encoders are connected over the
common DRIVE-CLiQ interface.
DRIVE-CLiQ has the following properties:
● Automatic recognition of the components by the SIMATIC Drive Controller
● Uniform interfaces on all components
● Consistent diagnostics down to the components
● Consistent service down to the components
● Each DRIVE-CLiQ interface has 24 V/450 mA for connecting encoders and measuring
systems.
Note
The DRIVE-CLiQ cable with its 24 V supply is only used for the components that require
it (for example motors with DRIVE-CLiQ interface).
Rules for DRIVE-CLiQ wiring
Rules apply for wiring components with DRIVE-CLiQ. A distinction is made between
mandatory DRIVE-CLiQ rules that must be observed and recommended rules.
Further information
You can find further information on DRIVE-CLiQ wiring in the following manuals:
● SIMATIC Drive Controller
(https://support.industry.siemens.com/cs/ww/en/view/109766666) manual
● SINAMICS S120 function manual
(https://support.industry.siemens.com/cs/ww/en/view/109763287); section on Rules for
wiring with DRIVE-CLiQ
● SINAMICS S120 Control Units and Supplementary System Components manual
(https://support.industry.siemens.com/cs/ww/en/view/109763286)
84
SIMATIC Drive Controller
System Manual, 11/2019, A5E46600094-AA