Installation; Unpacking; Mounting - Cardinal 200 Installation And Technical Manual

Unpacking

Carefully remove the indicator from the shipping carton and inspect it for any evidence of
damage that may have taken place during shipment. Keep the carton and packing material for
return shipment if it should become necessary. The purchaser is responsible for filing all
claims for any damages or loss incurred during transit.

Mounting

1. The Model 200 Weight Indicator is
housed in a NEMA 12/IP52 enclosure
that is normally mounted to a panel or
wall. Make certain the mounting surface
is strong enough to support the
indicator. The mounting location should
be where the display is easily viewed
while being close enough to provide the
operator easy access to the keypad.
2. Carefully lay out the mounting hole in
the panel or wall, and then cut out an
opening, referring to Figure No. 1 for the
cutout dimensions.
3. Remove the 2 screws securing the
mounting clamps to the enclosure. See
Figure No. 2.
4. Slide both mounting clamps toward the
rear of the indicator and remove. See
Figure No. 3.
5. Insert the indicator through the cutout in
the panel until the front bezel is resting
against the panel. Make sure the
indicator is facing in the correct upright
position.
6. Place both mounting clamps in the
groove on the side of the enclosure and
slide them forward to rest against the
panel. NOTE: The mounting clamps
are identical and have the same notch
on both ends. They can be used on
either side with either end against the
panel.
7. Install the 2 screws removed in step 2
and finger tighten.
8. While supporting the weight of the
indicator (to insure the bezel is flush
against the panel), tighten the 2 screws
to secure the indicator to the panel. See
Figure No. 4.

INSTALLATION

8200-M035-O1 Rev C  200 Installation & Technical
2.64"
(67 mm)
Figure No. 1
Mounting
Clamp Screws
Figure No. 2
Mounting Clamp
Figure No. 3
0.5"
(12.7 mm)
(221 mm)
Mounting Clamp
Figure No. 4
5.35"
(136 mm)
8.7"
7